empty field

[dr. A.S.J. Botenga]

It doesn't work. I have a datebase withe 4180 records one of the  
columns has a view information. But when I use the find/select  
possiblity and ask to selact at first the empty fields as I did before  
even if I use yuur suggestion  nothing happens, all the records who  
has a value are still there and the answer is: no records selected.
Op 4 mei 2008, om 20:47 heeft Jim Bailey het volgende geschreven:

> Why not simply select [FieldName]<>"" and get it over with ?
>
>
> ----- Original Message -----
> From: "William Conable" <conable.1 at osu.edu>
> To: "Panorama Questions & Answers (Discussion)" <qna at provue.com>
> Sent: Sunday, May 04, 2008 10:44 AM
> Subject: Re: empty field
>
>
>> Sylvia van der Heijden wrote:
>>> Hello,
>>>
>>> I have a question. Before the installation of Leopard I was used to
>>> select emptyfields and than select reverse so that the fields who
>>> where filled in with different items were selected at ounce. In
>>> panorama 5.5 this is not possible anymore. Can you give me some  
>>> advise.
>>>
>>> Kind regards
>>> Sylvia van der Heijden
>>> the Netherlands
>>> _______________________________________________
>>> Qna mailing list
>>> Qna at provue.com
>>> http://provue.com/mailman/listinfo/qna
>>>
>>>
>> Not quite clear what you are doing. When I select [fieldname]<"" and
>> then do select reverse, I get a selection including all the records
>> where that field is populated, just as I always have. I am using the
>> very latest versions of Panorama and Leopard.
>>
>> Bill Conable
>> _______________________________________________
>> Qna mailing list
>> Qna at provue.com
>> http://provue.com/mailman/listinfo/qna
>>
>
> _______________________________________________
> Qna mailing list
> Qna at provue.com
> http://provue.com/mailman/listinfo/qna