Ack!!

[Groover David]

OK, we all know that operator error is often the only reason Pan  
messes up - EVER  ;-). In my case this is quite often the case.  
However, after just entering in about four appointments in my  
calendar and saving, I began getting flaky response. Meaning, one  
form was showing one record and another form, from the same DB, was  
showing a different record. I should have had a clue as earlier I  
entered two appointments and only one was showing. Actually, it  
showed fine on the calendar DB and not where I use an arraybuild to  
show my appointments and my Todos on my contact mangers task list  
section. IT was on the task list section that it would only show the  
first one. Until I added the next appointment and then the old  
(second) one started showing again. (???)

Of course, after I closed the offending window, the DB suddenly quit.  
After reopening it, the work I had done, was gone.

Sigh... I still have work to finish the way I have this set up and  
repeating reminders seem still difficult but must be done. So it is  
possible I Left something in a procedure that made this all get all  
flaked up, as it were... But still, ACK!!

David Groover